The raw materials of the industrial mixing tanks are made of high quality 304 and 316L stainless steel materials, and the materials entering the factory must be strictly tested. The blanking needs to be lined with a marker according to the drawing size, and then completed by cutting, polishing, rolling and other processes. The cut sheet is rolled into a coiling machine and assembled and welded. After welding, the concavity, verticality and horizontality of the tank wall are all met. The operator should be familiar with the control system of the coiler, the method of operation and the bending process of the workpiece.
The surface of the industrial mixing tank body is rough and unclean when it is not polished, and the welding marks are obvious at the welding place. At this time, it needs to be polished to achieve a smooth and smooth surface. After the cylinder is finished, the upper and lower heads, the base and the bracket need to be assembled and welded. When welding, the concave and convexity of the tank wall, the verticality, and the horizontality of the upper and lower mouths are all met.
The mixing device of the industrial mixing tank is generally installed on the upper head, the base is welded at the opening of the upper head, and the stirring device is flanged to the base. The air compressor is used to test the pressure of the industrial mixing tank jacket; after all the welding is formed, each detail of the industrial mixing tank is finely polished to make the surface of the tank bright and mirror-finished.
After the commissioning is passed, the quality inspectors shall inspect the inside and outside of the industrial mixing tank. Detect qualified equipment and rinse it with clean water to remove surface dust and impurities. The stainless steel cans to be shipped from the factory are packed with fiber cloth to prevent the device from being bumped.www.chinachemicalequipment.com