Home > Exhibition > Content

Straightening machine adjustment method

Jun 28, 2019

Straightening machine We also said a lot in the previous introduction, I don't know if you know its adjustment method, because we can't adjust it in one step when we use the straightening machine, we have to adjust this time. So what is the specific method?

      

1. We must know that we can't put items on the straightening machine to avoid the object falling into the body due to vibration.

2. If the straightening block is not fixed or the protective cover is covered, we can't feed it. We can't open the protective cover during the operation.

3. We must maintain the corresponding distance after we send the steel bar to the impeller.

4. When the end of the steel bar is straightened, our operators should avoid it and avoid incitement and hurt people.

5. If the length of the steel bar is less than 2 meters or the diameter is greater than 9 mm, then we should use low speed to work.

6. After finishing the work, we will return the straightening block to its original position.

7. When checking the straightening machine, we can turn the flywheel by hand to adjust the gap. After normal, we will see if there is any sound in the bearing. If it is normal, we can work. www.chamferingmachinechina.com