The billet finishing line is a kind of finishing line, which contains a lot of knowledge content. Therefore, the next work is to explain the knowledge about the billet finishing line, so that everyone can have a deep understanding and at the same time, It is also possible to achieve rational use of the product and obtain good economic benefits.
1. Is the flaw detection in the billet finishing line important?
There are many processes and processes in the billet finishing line, and some of the processes and processes are indispensable, such as flaw detection work. Moreover, the choice of flaw detection methods and flaw detection tools or equipment is also important and cannot be underestimated. Generally speaking, the flaw detection on the billet finishing line is ultrasonic flaw detection, magnetic particle flaw detection, etc., and can be used alone or in combination.
2. Is the amount of steel used related to the billet finishing line?
However, from a professional point of view, there is no direct relationship between the amount of steel used and the billet finishing line. However, if the demand for steel is very high, the production capacity of the billet finishing line should be increased, and the production volume should be increased. Therefore, from this point of view, there is a certain relationship between the amount of steel used and the finishing line of billet.
3. Can I use advanced heavy-duty grinding wheels during billet finishing?
In the billet finishing process, it is possible to use an advanced heavy-duty grinding wheel, and it is used without any problem on the billet finishing line. The purpose of using this kind of grinding wheel is to repair the semi-finished steel products such as billet, billet, steel ingot and steel plate, and also to clean the surface of various castings to ensure high quality steel. In addition, this kind of grinding wheel should also pay attention to the material type and the distribution ratio, because only in this way can the high-quality heavy-duty grinding wheel of good quality be obtained.
4. What are the key factors for the finishing ability of billet in unit time?
On the billet finishing line, the key factors for the finishing ability of the billet in a unit time can be obtained by using the Six Sigma method and using the fishbone chart, the two-sample T test, the analysis of variance and the multi-variogram. It is for the completeness of the billet, whether it is defective, and the quality and effect of grinding. Moreover, these are important factors that cannot be ignored.http://www.chamferingmachinechina.com/